leak
-
V
diff leak
hey guys, i done my first trackday today and my diff sprung a leak, it was always kind of leaking a bit but never too serious, but today it got worse it was actually dripping :( what i dont no is exactly where its leaking, its either the diff casing or the driver side output shaft, what i want...- vti_coupw
- Thread
- Replies: 3
- Forum: Mechanical & Bodywork
-
Small Oil Leak
OK Ive discovered I have a very slight oil leak on my car (about a teaspoon every 2 weeks). Now I know what 90% of you are thinking right now and that is turbo oil line. Well from what I can see thats all dry so Im quite sure its not comming from there, and I put braided lines on last year so...- Darren_S15
- Thread
- Replies: 5
- Forum: Mechanical & Bodywork
-
A
Minor boost leak / squeak!
Just had my engine mounts changed, and since i have got the car back i think i have picked up a really minor boost leak.. (Not noticing a drop in boost on either the pillar guage or B/C readings) however on full boost (under load only) i get what can only be described as someone letting air out...- als_jordan
- Thread
- Replies: 6
- Forum: Mechanical & Bodywork
-
D
Sandwich plate leak!
Just noticed a small leak it seems to be coming from the oil pressure sender in the plate. I did use plummers tape so i dont know whats wrong and dont like the taughts off taking it apart again! anyone had this problem?- david
- Thread
- Replies: 3
- Forum: Mechanical & Bodywork
-
1
Hot eratic idle
My car has been have eratic idle. (almost stalled when put into neutral when coming to a stop). This only happen when the car is hot lets say after 1/2 hour of driving. Friend suggested boost leak, will check later when free, but just hope anyone got a 2nd opinion? Thanks in advance.- 130r
- Thread
- Replies: 7
- Forum: Mechanical & Bodywork
-
oil leak...
hey guys ive got a leak but duno where its coming from its turbo side of the engine what can leak from that side is it more likely to be the turbo oil inlet pipe...?? need this sorted soon :(- sushiming
- Thread
- Replies: 24
- Forum: Mechanical & Bodywork
-
D
over boost....
well, at first i thought it was just boost creep after installing my elbow/downpipe... but, i've since fitted my EVC and i can't get the boost to hold below 1 bar. Wondered if it was a fault unit.... So, i plumbed in a pipe, directly from the intercooler feed to the actuator, and still get the...- Dazz0i
- Thread
- Replies: 34
- Forum: Mechanical & Bodywork
-
Checking turbo area for leaks.. how?
I've had some problems since I fitted my turbo-elbow (I think it started then). It had started to leak somewhere and I get the tractor sound when revving. Not fully sure if it's the dump-pipe or the manifold which is creating the leak. How can I tell without ripping the turbo and stuff out? I...- Yakozan
- Thread
- Replies: 17
- Forum: Mechanical & Bodywork