boost

  1. H

    Nissan S15 sputters / hesitates during full throttle

    Make a short story of this. Ran the car home to give it a wash. 1.5h later and good to go I noticed it started to sputter / hesitate during full throttle :confused: Now I been tried to fix this issue by change; Brand new plugs, bkr7e re-gapped to 0.7 New fuel pump (from nissan r34 gtr) Coil...
  2. A

    Intermittant electrical problems when starting the engine.

    So I have the key turned to ACC & everything electrics wise is fine, I start the car & all the radio/boost controller screen etc goes off while it starts & then the radio etc comes back on. But sometimes the little boost controller screen just says ERROR & beeps continuously or occasionally...
  3. Hairy Fish Nipples

    Oil light with boost

    Hi Peeps, I have noticed that if I accelerate my S15. The oil light will come on after a certain boost pressure. I do not know if it is a certain rev range or a certain bar pressure that instigates the oil light to come on. Car has been de-mapped to 1.1 bar (not sure what that works out as in...
  4. B

    Dan's daily driven project

    Hey guys, I've been loitering and posting on here for a short while, thought I'd throw this up. So, my last car: A Honda Civic Type R, FN2. It really was difficult putting her up for sale, she was such a good car and a really reliable car. Unfortunately for the FN2, however, I'm now insurable...
  5. T

    Boost readings

    Hi guys. My boost gauge has started reading low. My HKS evc reads 0.7bar and my gauge used to match this, now the ebc reads the same but the gauge is only showing 0.25bar. It's still pulling strong though, definitely making some boost. The way it, either the boost gauge has died, it still...
  6. FreakensNL

    Stock high rev boost creep? 0,6->1,0bar

    With open waste-gate still 14 psi Update: with waste-gate tied open I still get 7psi @ 4k rpm, than goes to 14psi till redline... https://youtu.be/HyHDuydxjlM Problem is i am running stock tune, so @ 14psi i'm seeing AFR's of 14.5 (between 3.5-4,5k rpm) AFR at high rev's is good, 11 a 12...
  7. FreakensNL

    White S15 Spec-R

    Fellow S-owners, After owning a 200sx hatch with GT28R @ 1.3bar of boost; And owning a R33 GT-R V-Spec @ 1 bar; loved them both but preffer the ligther Rwd type cars so I'm really happy to say "got myself a S15" ; Interior: Apexi RSM Speed de-limiter (gonna remove when I get Nismo...
  8. dave_t

    WTB: Defi Boost Sensor (Link BF Series)

    I am after a replacement Defi Boost Sensor, for the Link BF series to fit the Control Unit II Example: PM me if you have one :thumbs: -David
  9. W

    FS: Apexi avcr black edition

    As above few minor scratches nothing bad as you can see from the pictures, loom looks to have been extended at some point, works perfectly and held rock solid boost £250 delivered
  10. JDM_virgin

    Boost gauge and EBC question

    Morning folks, Had some time at the weekend to plumb in my EBC and also my aftermarket boost gauge (depo). The EBC I have is a Gizzmo and was a doddle to fit and plumb into the induction/boost system- I actually used a guide i found on here over the instructions in the box as it had pictures...
  11. S

    WTB: Boost pillar cover

    Hey guys I'm after the cover that goes over the factory boost gauge, the part number is 76987 85f10. I Iive in Sydney Australia so closer the better Sent from my iPhone using Tapatalk
  12. S15AK

    WTB: Dirvers A pillar with boost gauge holder

    Hi I'm after the drivers side A pillar from the spec R which has the boost gauge, not bothered if the gauge is broken as I will be upgrading it anyway. Cheers Edit - I will have a flush one as exchange if anyone wants to swap..
  13. R

    FMIC (boost controller?)

    I've tried reading into this and not finding a lot of information. I've got a FMIC installed and it going in for an MOT/TAX/Insurance soon ready for summer :) Do I need to get a Boost controller with this FMIC? Just wondering what other people have done as I've heard just fitting an FMIC can...
  14. A

    factory boost gauge stopped working.

    I just noticed on the way home the A-pillar boost gauge is not working anymore, is there anything obvious I can check or is it usually just broken? Thanks.
  15. P

    FS: Blitz SBC Type S Boost Controller - unused

    Purchased August 2014 from funkypower.co.uk, never used, still in box. Just after it was delivered to me and before fitting the EBC I unfortunately wrote off the car :( funkypower told me that they do not accept returns on electronics so I am advertising on here. I paid £346 so am looking for...
  16. N

    Fitting aftermarket boost gauge

    How have people fitted their 60mm boost gauges in the stock a pillar pod? Ive filed away the tabs inside the pod but it's still about 1cm away from the edge. I cant leave it at that either cuz the gauge can move about. Any help would be appreciated :)
  17. Packham

    Boost cut with Apexi avcr

    Evening all. Wondering if anyone has ever had this? My car seems to be cutting out on boost. Put new plugs in and it's now doing it from 4.5k rather than 3k rpm. I have decided to set my boost controller to off and it's boosting fine up to just above 0.5 bar with no boost cuts. Could it be...
  18. N80Jamie

    WTB: Electronic Boost Controller

    Would prefer an HKS EVC 5 + but will consider others! Sent from my iPhone using Tapatalk
  19. S

    Help for next mods...

    Hi, I'm looking for some advice on what to do next with my S15. I brought it about a month ago with these mods: Greddy intercooler Greddy profex boost controller Z32 air flow meter Nistune ecu + remap Hks actuator Apexi intake Splitfire coilpacks Walbro fuel pump Japspeed down pipe Japspeed...
  20. C

    Basic tuning on S15

    So I'm having a bunch of trouble with my engine, soon as I turn the boost to 0.7bar or more, the engine won't rev cleanly over 6000, splutters and has no power. Now, I've logged it on datascan and it shows the MAF flat lining at 4.71v and injector duty going to 103%. I don't get it, I have...
Top