wear
-
A
WTB: Carbon bonnet
As above gang let me know what you have? also after oem gear gaitor tears and wear is fine as I am only after trim that glued to thanks- Almeida1234
- Thread
- Replies: 0
- Forum: Car Parts for Sale (Silvia)
-
FS: Recaro seats. Bride rail
Bride seat rail Base mount Drivers side sliding rail SOLD Blue recaro tilting seats Very good condition, no wear, rips or tears. Bolsters are perfect. There is some small wear on the harness holes bit nothing major. No rails €375 £320 plus delivery Any interest message me on this or...- s15Irl
- Thread
- Replies: 0
- Forum: Car Parts for Sale (Silvia)
-
WTB: Anyone breaking? - Need front part of Drivers Side Wheel Arch
Mine decided to come loose on the motorway and its now a little worse for wear.. If anyone has one or knows anyone breaking an S15 please let me know. Thanks, Jamie.- N80Jamie
- Thread
- Replies: 4
- Forum: Car Parts for Sale (Silvia)
-
S
FS: Bride brix 2
Forsale is my bride brix 2 reclining seat, comes with S13,14,15 genuine bride seat rail drivers side the seat is in excellent condition with minor wear to the upper bolster foam, no rips or wear in the material £425 for seat and rail collection from Staffordshire preferred but can arrange...- s15-liam
- Thread
- Replies: 0
- Forum: Car Parts for Sale (Silvia)
-
N
FS: s15 leather seats
SUPER RARE! :) just putting these up to see if there is any interest, not pushed on selling as i will have no seats if they sell haha! small bit of wear on drivers side bolster (2nd pic) but other than that mint! 450 pounds but open to reasonable offers :)- nikkisixx69
- Thread
- Replies: 17
- Forum: Car Parts for Sale (Silvia)
-
D
FS: Advan AVS 6 spoke 17" wheels
Got six of these pics and sizes etc below. All in good condition, only one mark between all of them. All the offsets and tyres are a bit muddled up, but you can get a matching set of 17x8 front and 17x9 rear. 255's on the rearts and brand new, 225's for the front have loads of tread, but have...- drifter
- Thread
- Replies: 0
- Forum: Car Parts for Sale (Silvia)
-
crank shaft wear
Hi Guys, wonder if anyone heard of crankshaft wear that requires machining. My ride had some noise and we suspected it as bearings wear. We had it changed but still the noise is there. Then we think its got to do with the crank shaft wear. My mileage is about 145,000 km. Any ideas or similar...- sjt47y
- Thread
- Replies: 0
- Forum: Mechanical & Bodywork
-
FS: S14 sr20det engine parts and block
hi there i am pawning off all parts from my s14 sr20 collection i,e sr head with wear but whole with non rattle vvt. sr bottom end with 1mm overbore again with wear on cylinders crank unknown but can be checked. (crank sold) Forged pistons (sold) New timing chain was fitted before the engine...- roachey
- Thread
- Replies: 2
- Forum: Car Parts for Sale (Silvia)
-
FS: SR20DET and parts
i am selling an sr20det engine. The engine is in need of some work as it has bad compression but through some checking it appears that the rockers and the shims that hold the rockers to the springs were not installed properly by the previous owner!!! The head has been stipped down for veiwing if...- roachey
- Thread
- Replies: 0
- Forum: Car Parts for Sale (Silvia)
-
I'm back
Oh yes i'm back on the road. finished fitting the new orc ogura Clutch & lightened fly wheel late last night & this morning I tightened up all pipes clips hoses etc. Took it out for a spin & all is good :thumbs: The clutch has very short travel so may extend the fork but only if I feel I have... -
Uneven tire wear and some other things..
Ok so ive been driving the car for a bit now and am quite happy but i was doing an oil filter the other day (what a :censored:!!) and while i had the car jacked up i checked the front tires and there is wear on the inside of them. Im wondering what i need to adjust the camber on the front? The...- slammedmind
- Thread
- Replies: 9
- Forum: Mechanical & Bodywork